Table of Contents
Advertisement
Select On to use Unicable and set the Unicable in the
When Unicable is enabled,
Motor Type
Select Motor Type to use Motor and set the Motor in the Motor Setting menu. When
Motor is enabled,
If you set satellite to others, you must add a transponder using Transponder Edit.
When selecting 22kHz Tone and DiSEqC, you must connect them in the same position as
displayed on the OSD.
If you delete a Satellite, all programmes stored in the Satellite are deleted.
Set Motor Setting
DiSEqC 1.2
: Control motor to change satellite dish position.
Drive Direction
Select the direction in which you want to move the motor.
Drive Mode
Two modes are available : Step and Continuous.
Step : The motor moves based on the value you enter (from 1 to 128).
●
Continuous
●
Test Transponder
Select the test Transponder you want to tune.
Set Limit
Set the motor movement to east or west to have the motor move only within the
direction set.
On : You can limit the movement to the current direction by selecting the West/East.
●
Off : You can cancel the limit you set.
●
Go to 0
You can move the motor to Zero.
22kHz
22kHz
Tone, DiSEqC,
: The motor moves continuously until you press the Stop.
Tone, DiSEqC,
Motor Type
Unicable
are disabled.
99
Unicable Settings
are disabled.
menu.
Advertisement
Table of Contents
