Page 1
8250 D Sub Connector. The termination of D Sub Connectors. 3M assembly equipment 3443-112 Locator Plate is used with the 3442-1A Platen to is offered to reduce set-up time, to provide easier and assemble the 8350 D Sub Connector.
Page 2
Procedures for Adjusting Shut Height Shut height settings are guidelines for proper termination depth. The shut height adjustment is made from the base of the assembly press without the locator plate and platen in place. Press Shaft Shut Height Gauge 1.
Page 3
Procedures for Connector/Cable Assembly 1. Grasp a D Sub cover strip between thumb and forefinger of both hands, with the liner facing you. Rotate the outermost cover down against the adjacent cover on the strip, breaking it from the liner. Pull laterally away from the strip.
Page 4
Contact 3M Electronic Products Division Customer To receive this technical document via fax on demand, Service for health, safety and environmental call the 3M Automated Information Response System information. Technical, sales and ordering at 1-800-225-5375. Use tech sheet number TS 0764-01.