Procedure - Canon imageRUNNER 2520 Series Service Manual

Procedure

MEMO:
The procedure for upgrading Boot is described below as a typical example. Use the
same procedure for other firmware.
1) Turn ON the power switch of the PC and start up the UST.
2) When the power switch is turned ON, a Found New Hardware Wizard appears. Click
[Cancel].
3) Enter the service mode. ( key > 2 Key > 8 Key >
4) Select [DOWNLOAD] by pressing the arrow key, then press the [OK] key.
MEMO:
You can also enter the download mode from the following user mode:
> System Settings > Firmware Upgrade > Yes
5) When "USB DOWNLOAD AVAILABLE" is displayed, start up the UST.
All manuals and user guides at all-guides.com
F-7-2 F-7-2
key)
6) Click [Next] following the instruction shown on the screen.
7) Click [Next] following the instruction shown on the screen.
F-7-3 F-7-3
7
F-7-4 F-7-4
7-3