Maintenance And Servicing - Norton clipper CDR 133 Operating Instructions And Spare Parts List

VERS.2015.05.19

6 MAINTENANCE AND SERVICING

To ensure a long-term quality from the cutting with the CDR 133, please follow the maintenance
plan below:
Whole machine
Motor cooling fans
Switch, cables and extension cables
Water hoses and nozzles
Motor housing
Reachable nuts and screws
Service the machine only while it is switched off and isolated from the electrical supply.
Cleaning the CDR 133
After work, blow dirt and dust out of all air vents with dry air. Wear protective goggles and mask for
this operation.
Switch, cables and extension cables
Check visually that switch, cables and extension cables are not damaged. If so, get them replaced
by a qualified electrician.
Inspection and control
Return your core drilling motor for service to your nearest service centre at least every 200 hours of
work. At this occasion, ask for the renewal of your carbon brushes.
Visual control (general
aspect, watertightness)
Clean
Blow the dirt and dust
Inspect
Clean
Clean
Tighten up
Kit CDR 133 + CDM 163_MAN_EN
19