Maintenance And Servicing - Norton clipper CDR 353 Operating Instructions Manual

VERS.2015.05.19
6

MAINTENANCE AND SERVICING

To ensure a long-term quality from the cutting with the CDR 353, please follow the
maintenance plan below:
Whole machine
Motor cooling fans
Switch, cables and extension cables
Water hoses and nozzles
Motor housing
Reachable nuts and screws
Service the machine only while it is switched off and isolated from the electrical supply.
Cleaning the CDR 353
After work, blow dirt and dust out of all air vents with dry air. Wear protective goggles for this
operation.
Switch, cables and extension cables
Check visually that switch, cables and extension cables are not damaged. If so, get them
replaced by a qualified electrician.
Inspection and control
Return your core drilling motor for service to your nearest Service Center at least every 200
hours of work. At this occasion, ask for the change of your carbon brushes.
20
Visual control (general
aspect, watertightness)
Clean
Blow the dirt and dust
Inspect
Clean
Clean
Tighten up
Kit CDR 353 + NBM 351_MAN_EN