Table of Contents
Advertisement
VERS.2015.05.19
1.3 Safety instructions for particular operating phases
Before commencing work
Before commencing work, make yourself familiar with the working environment at the place of
use. The working environment includes: obstacles in the area of work and manoeuvre, the
firmness of the floor, necessary protection at the site relating to public thoroughfares and the
availability of help in the event of accidents.
Immediately remove damaged or badly worn core bits, as they endanger the operator whilst
rotating.
Only fit NORTON diamond core bits to the machine! The use of other tools can damage the
machine!
Read the core bits' specifications carefully to choose the adequate tool to your application.
Make sure the handle of the machine is free from oil or grease.
Attention is drawn to the use of BS2092 safety goggles in conformity with specified Processes
No.8 of the Protection of Eyes Regulation 1974, Regulation 2(2) Part 1.
Make sure that no mounting tool is left on the machine before starting it.
Electrical powered machine
Make sure that the electrical supply of the machine is equipped with a grounded protective
connector. If you have doubts, let a qualified electrician check the electrical system.
Never pull the machine by the cable to transport it or to separate it from the electrical supply.
Avoid any contact between the cable and extension cable and heat sources, oil, and sharp
edges.
Always check the cable before commencing work. If it is damaged, let a qualified electrician
replace it.
Switch the machine off, and isolate it from the main electrical supply before attempting any
maintenance or repair on the machine
In the event of the machine breaking down or stopping for no apparent reason, switch off the
main electricity supply. Only a qualified electrician is allowed to investigate the trouble and
remedy the fault.
Always isolate the machine from the electrical supply when not in use.
8
Kit CDR 133 + CDM 163_MAN_EN
Advertisement
Table of Contents
