Larson Electronics FRL-4P-S1-60-1X-T5HO-130W-UVC Instruction Manual

130W Spare/Replacement UV Fluorescent Bulb for Germicidal Lights
Thank you for your purchase of the Larson Electronics FRL-4P-S1-60-1X-T5HO-130W-UVC.
EPA Reg. No 98409-1
EPA Est. No. 98409-TX-1
WARNING:
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
CRITICAL SAFETY INSTRUCTIONS:
• INSTALLATION SHOULD ONLY BE CONDUCTED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH NEC AND ANY
RELEVANT LOCAL BUILDING CODES.
• RISK OF FIRE OR ELECTRIC SHOCK. FIXTURE INSTALLATION REQUIRES KNOWLEDGE OF FIXTURE'S ELECTRICAL
SYSTEMS. IF NOT QUALIFIED, CONTACT A QUALIFIED ELECTRICIAN.
BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.
•
MAKE SURE THE SUPPLY VOLTAGE IS THE SAME AS THE FIXTURE'S RATED VOLTAGE.
•
TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR SHARP
•
OBJECTS. SUITABLE FOR DAMP LOCATIONS.
The Larson Electronics FRL-4P-S1-60-1X-T5HO-130W-UVC is a Spare/Replacement UV Fluorescent Bulb for Hazardous Location
Lights and Industrial Lighting Systems. This 130-watt unit offers 50 watts of UV-C output at a range of 200nm - 280nm (254nm).
Featuring a 4-pin socket, this 60-inch UV-C high output T5HO tube emits a flood beam pattern and is powered from one side only.

INSTALLATION AND USE

The FRL-4P-S1-60-1X-T5HO-130W-UVC provides UV-C illumination in industrial sites and hazardous locations. This 130-watt
spare fluorescent bulb offers 50 watts of UV-C output within the 280nm-200nm UV-C range (254nm peak). Equipped with an
expected lifespan of 13,000+ hours, the lighting accessory emits a flood beam pattern. This UV-C unit is compatible with single-
ended 4-pin fixtures that accept T5HO bulbs. This lamp DOES NOT produce ozone. Install the bulb into a compatible fixture, first
making sure the power is disconnected to the fixture. Again, do not touch the bulb with your bare hands. If you do get fingerprints
on the bulb, clean them off with a non abrasive cloth and alcohol before powering on the bulb. Ultraviolet light is harmful to skin
and eyes. Always wear skin and eye protection when being exposed to this light, and never look directly into the bulb.

LAMP CARE

Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.
Always check for damaged or worn out parts before using the device. Avoid touching the lamp with bare skin, and clean
any oils off the lamp using a non abrasive cloth and alcohol.

REPLACEMENT PARTS

The FRL-4P-S1-60-1X-T5HO-130W-UVC is designed to provide 13,000+ hours of reliable performance. Should the need
for replacement parts arise, please contact Larson Electronics.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.
SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
SALES@LARSONELECTRONICS.COM
PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.
Larson Electronics, LLC
60" UV-C - T5HO 4-Pin Lamp - Single End Power
Instruction Manual
OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.
Phone: (800) 369-6671
FRL-4P-S1-60-1X-T5HO-130W-UVC
Fax: (903) 498-3364 www.larsonelectronics.com
1 of 2