Larson Electronics EPL-HB-100LED-RT-UVA Instruction Manual

Class 1 Division 1 Explosion Proof 100 Watt
Ultraviolet LED Light Fixture - Paint Booths - 365NM
The Larson Electronics Explosion Proof Ultraviolet light fixture provides operators with a powerful and
energy efficient alternative to traditional hazardous location luminaires. This fixture uses advanced
LED light technology to produce ultraviolet light and is T6 rated for hazardous locations where UV
lamps are used in paint and adhesive curing, food inspection or for non-destructive testing.
Lamp is available in 100-277V AC Model or 11-25 Volts AC/DC Model. Check product for correct
voltage before energizing!
100-277V AC Model
An internal, universal input, power-factor-corrected switch-mode supply allows it to be used from any
nominal 100-277V AC 50/60 Hz power supply without any variation in light output.
11-25V AC/DC Model
A universal input, power-factor-corrected switch-mode supply allows it to be used from any nominal
11-25V AC/DC power supply without any variation in light output.
WARNING
To avoid the risk of fire, explosion or electric shock, this product should be installed, inspected
and maintained by a qualified electrician only, in accordance with all applicable electrical codes.
To avoid electric shock:
•
Be certain electrical power is OFF before and during installation and maintenance.
•
Luminaire must be connected to a wiring system with an equipment-grounding conductor.
To avoid explosion:
•
Make sure the supply voltage is within the luminaires' voltage rating.
•
Ensure the marked T rating is less than the ignition temperature of the Hazardous
Atmosphere.
•
Do not operate in ambient temperatures above those indicated on the luminaire nameplate.
•
Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.
For supply connections, use wire rated for at least 110°C
Recommended mounting height is 25-40 feet.
MOUNTING
This fixture offers an adjustable mounting system that allows this fixture to be mounted to any flat
surface including walls and ceilings. A single ½-13 bolt is used to mount the fixture to the surface.
Check to ensure that all mounting hardware is included.
• 2 Small Brackets
• 1 Large Trunnion Bracket
• 8 Bolts
• 8 Lock-Washers
• 4 Nuts
Larson Electronics, LLC
Instruction Manual
Phone: (800) 369-6671 Fax: (903) 498-3364
EPL-HB-100LED-RT-UVA
www.larsonelectronics.com 1 of 2