Table of Contents
Advertisement
74
en | Using your MIC Camera
12.5
Using the Wiper/Washer (Bosch Protocol)
The "predefined position" for the wash/wipe function is preset 62. The installer must define
preset 62 (preferably where the washer nozzle is located and can direct washer fluid towards
the camera window) before using the wiper/washer function.
To activate the washer/wiper function, press ON-105-ENTER and confirm this sequence:
1.
2.
3.
4.
To activate the wiper manually (or if the corresponding alarm was activated or
deactivated):
Press ON-102-ENTER.
Note: The wiper will turn off automatically after 5 minutes of use.
To activate intermittent wipe:
Press ON-103-ENTER. The wiper wipes twice, then returns to parked position, and then turns
off 15 seconds later.
To activate the wiper to wipe five (5) times:
Press ON-104-ENTER. The wiper wipes five times, then returns to parked position and turns
off.
Notice!
If the power fails while the wiper is activated, the wiper will return to parked position, after
power is restored, before turning off. The wiper will not stop in front of the camera window.
2017.11 | 0.20 | F.01U.349.011
The wiper moves to a predefined position.
The washer turns on for five seconds. Simultaneously, the wiper turns on and wipes five
times.
The washer turns off. The wiper turns off.
The camera returns to its previous PTZ position (and to inactive mode if applicable).
User Manual
MIC IP fusion 9000i
Bosch Security Systems
Advertisement
Table of Contents
