Tools Required For Control Valve Installation - DANIEL 762 User Manual

Table 5-2:
Nominal pipe size
(NPS)
3
4
6
8
10
12
16
The position of the number 1 screw determines the position of the clockwise rotation of
the subsequent screws.
5.5

Tools required for control valve installation

Flange installation tools
Follow all best practice procedures when installing or removing flanges.
Control valve components
The control valve does not have pre-installation requirements. If installation is required for
maintenance purposes, use the following tools:
• Socket wrench
• Adjustable wrench
• T-handle or extended Allen wrench
• Arbor press (may be needed for 4- and 6-inch valves)
• Retaining ring pliers
User manual
Cross-pattern tightening sequence when using single tool
Daniel Class 150
1-3-2-4
1-5-3-7 2-6-4-8
1-5-3-7 2-6-4-8
1-5-3-7 2-6-4-8
1-7-4-10 2-8-5-11
3-9-6-12
1-7-4-10 2-8-5-11
3-9-6-12
1-9-5-13 3-11-7-15
2-10-6-14 4-12-8-16
Installation prerequisites
(continued)
Daniel Class 300 Daniel Class 600
1-5-3-7 2-6-4-8 1-5-3-7 2-6-4-8
1-5-3-7 2-6-4-8 1-5-3-7 2-6-4-8
1-7-4-10 2-8-5-11 1-7-4-10 2-8-5-11
3-9-6-12 3-9-6-12
1-7-4-10 2-8-5-11 1-7-4-10 2-8-5-11
3-9-6-12 3-9-6-12
1-9-5-13 3-11-7-15 1-11-6-16 3-13-8-18
2-10-6-14 4-12-8-16 5-15-10-20 2-12-7-17
4-14-9-19
1-9-5-13 3-11-7-15 1-11-6-16 3-13-8-18
2-10-6-14 4-12-8-16 5-15-10-20 2-12-7-17
4-14-9-19
1-11-6-16 3-13-8-18 1-11-6-16 3-13-8-18
5-15-10-20 2-12-7-17 5-15-10-20 2-12-7-17
4-14-9-19 4-14-9-19
www.Daniel.com
USER MANUAL
67
71