Table of Contents
Advertisement
__ • Two power cords for connection to rack-mounted power distribution units
__ • Drive bay blanking plates (installed in the enclosure)
Options applicable to control enclosures
__ • Fibre Channel cables
__ • SAS cables
__ • Drives
__ • Power cords for connection to wall sockets
Identify the hardware components
Before you install your system, review and identify the hardware components and port locations for the
control enclosure and expansion enclosure on the system.
Control enclosure components
The following figures show the rear view of the Storwize V5010E and Storwize V5030E control
enclosures. The location of the power supply units and node canisters are also shown.
Figure 4 on page 15 shows the Storwize V5010E control enclosure.
Figure 4. Storwize V5010E control enclosure
Figure 5 on page 15 shows a rear view of the Storwize V5030E node.
Figure 5. Storwize V5030E control enclosure
Data ports
The following figures show the location of the ports that are available at the back of the Storwize V5010E
and Storwize V5030E control enclosures.
Note: The figures show an enclosure that is equipped with alternating current (AC) power supplies. Some
enclosure models have direct current (DC) power supplies. For more information about DC power supply
units, see "Direct current power supply units" on page 16.
Figure 6 on page 16 shows the Storwize V5010E control enclosure.
Chapter 3. Before you begin the installation 15
Advertisement
Table of Contents
