External Circulating Fan - dji MATRICE 30 Dock Bundle Series Maintenance Manual

1. Drive Shaft
2. Dock Cover Motor
3. Motor Driver
4. Main Controller Module
5. Return Vent
6. Supply Vent
7. Air Conditioning Controller
8. Position Sensor
9. Magnetic Ring

External Circulating Fan

• Make sure that the dock is powered off and the external circulating fan stops spinning
before operation.
1. Take photos to record the wiring status of the air conditioning module.
2. As shown in the figure, remove the connection cable of the external circulating fan (HOT-FAN),
toggle the lock clips, and then remove the fan.
3. Visually check the fan blades. Gently toggle the blades with a screwdriver to check if the
blades can rotate smoothly.
4. Clean the fan using the soft brush and the dust blower.
5. Follow the steps in reverse to install the external circulating fan. Make sure to avoid
damaging the connection cable.
DJI Matrice 30 Series Dock Bundle Maintenance Manual
HOT-FAN
©
2023 DJI All Rights Reserved 15