Banner Sure Cross Snap Signal R70SR Manual

R70SR SNAP SIGNAL™ Serial Data Radio
R70SR Features
Sure Cross® R70SR Serial Data Radios are compact, industrial, low-power wireless communications devices used to extend the range of
serial communications networks. The Serial Data Radios are available in two frequencies, 900 MHz and 2.4GHz, and are fitted with M12
quick disconnect connectors for fast deployment.
For additional information, updated documentation, and a list of accessories, refer to Banner Engineering's web­
site, www.bannerengineering.com.
R70SR Models
Models
R70SR9MQ
R70SR2MQ
Quick Start Guide
Setting Up Your Data Radio Network
To set up and install your wireless Data Radio network, follow these steps:
1. Before installing your data radios, verify that your serial devices work. Connect your serial devices using a serial cable.
2. Configure the DIP switches of all devices.
3. Apply power to all devices.
4. Form the wireless network by binding the repeater and peripheral radios to the controller/primary radio.
5. Observe the LED behavior to verify the devices are communicating with each other.
6. Install your wireless sensor network components. For more details about installing your radios, refer to the
Guide (p/n 151514) downloadable from the Wireless Reference Library at www.bannerengineering.com.
Buttons and LEDs
Original Instructions
June 23, 2023
• RS­485 serial communication
• Star or tree network topology configuration
• DIP switches select operational modes
• Frequency Hopping Spread Spectrum (FHSS) technology ensures reliable data delivery
• Self-healing, auto-routing radio frequency network with multiple hops to extend the network's
range
Frequency
900 MHz ISM Band
2.4 GHz ISM Band
Binding button, LEDs, and DIP switches
© Banner Engineering Corp.
Transmit Power
1 Watt
65 mW (100 mW EIRP)
Binding button
LEDs
Sure Cross Installation
p/n: 233275 Rev. A
233275