Advertisement
Table of Contents
S
C
W
®
ure
roSS
ireleSS
Wirelessly Connect the Banner Sensors GUI to an
R-GAGE or M-GAGE
o
vervieW
This guide shows you how to use two MultiHop data radios to extend the range of the Banner Sensor GUI software for interfacing with
the M-GAGE and R-GAGE. The two data radios create a wireless RS-232 extension for the DB9RJ11-07 cable.
Note: This has been tested to work only with R-GAGE and M-GAGE sensors.
P
l
arTS
iST
• DB9RJ11-07 (83338) Cordset Assembly RJ11 to DB9 PC Interface
• DX80SR9M-H (44053) MultiHop Data Radio, qty 2
• DPB1 (02984) Programming box – Modified for pass-through function
• SP-DPB1 (72782) Power Supply for DPB1
• 24 V dc Power Supply for the Serial Radios, qty 2
Note: Contact the factory to have the DPB1 modified for pass through functions.
b_4158230
Banner Engineering Corp. 9714 Tenth Ave. No., Minneapolis, MN USA 55441 • Phone: 763.544.3164 • www.bannerengineering.com • Email: sensors@bannerengineering.com
T
n
eChniCal
oTe
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Banner SureCross
Summary of Contents for Banner SureCross
- Page 1 This guide shows you how to use two MultiHop data radios to extend the range of the Banner Sensor GUI software for interfacing with the M-GAGE and R-GAGE. The two data radios create a wireless RS-232 extension for the DB9RJ11-07 cable.
- Page 2 7. Connect the R-GAGE or M-GAGE to the DPB1. 8. Start up the Banner Sensor GUI in either standard or engineering mode and select the correct communication port. 9. Changes the number of retries in the GUI to 10 and leave the default baud rate at 19200.
Need help?
Do you have a question about the SureCross and is the answer not in the manual?
Questions and answers