Switch From Brushcutter To Trimmer; Replacing Cord; Fuel - Texas A/S BC358D User Manual

6. Switch from Brushcutter to Trimmer

Removing blade - figures 6, 7, 8.
1. Insert the Allen wrench (1) provided into trimmer gear hole and bushing (a) to secure
the shaft.
2. Screw off the nut (f).
3. Remove cup (d), washer (c) and blade (b).
Note! Keep blade parts together for later use.
Fitting trimmer head – figures 14, 15, 16, 17.
1. Mount bushing (a)
2. Place the provided allen wrench (1) in the hole in the gearhousing, make sure it goes
through the hole in the bushing (a), so it is locked.
3. Mount the trimmerhead (c) (turn counterclockwise), make sure it is tightenen proberly.
4. Remove the allenwrench before use.

7. Replacing Cord

1. Stop engine.
2. Press each side of cord housing. Remove lid.
3. Remove roll by pulling. Allow spring to remain on spool. Remove any cord residue.
Take 3-4 m of cord (2.4 mm) and double it up.
4. Insert both ends into the 2 holes on the roll. Wind cord onto roll in direction of arrow.
Avoid twisting cord. When twine is fully on roll, cut and insert the two cut ends through
the guide holes.
5. Assemble cord housing in reverse order, starting with spring. Place cord in cord
housing holes.
6. Re-place cover. Check cover is secure.
Figure 10.

8. Fuel

1. This product is equipped with a 4-stroke engine.
2. Always use unleaded gasoline (minimum octane 95)
3. Use a clean,approved gas can.
4. Do NOT use a gasoline mixture that is more than 90 days old, as it can cause
problems starting engine. Do not store the same gasoline in tank for more than 30
days.
5. Always drain tank prior to long-term storage.
Allow engine to cool for at least 2 minutes before fuelling.
Remove filler cap slowly. Place on a clean surface.
Carefully pour fuel into tank, avoiding spillage. Replace and tighten filler cap immediately.
Wipe up spilt fuel.
Always ensure trimmer head is secured tightly.
NEVER OVERFILL THE REEL!
If in doubt, contact your nearest dealer.
24