Advertisement
RESTORE PARAMETER FROM AZL2x TO LMV..
To copy the previously saved configuration on AZL2x proceed as follows:
access up, press F and A at the same time
enter the password following the procedure on chapter "Programming LMV2x".
Press ENTER until the display will show:
To copy the configuration from AZL2x to LMV. It is important that the type of LMV is the same (for example LMV20
with LMV20, etc.) and that 113 "Burner ID" of the burner is the same value that is saved in the configuration you
want to copy.
With the buttons
113 parameter "Burner ID", press
iWith the buttons
press
the disply show
After about 5 seconds the restore process ends and the display shows
Now, LMV has the same configuration that was stored on AZL2x.
go to the group 100 of the parameters, press на
and verify (and/or change with buttons by pressing enter to confirm)
go to the group 000 of the parameters, press
press again
with the button + select 1 and start the restore process by pressing
and always with the buttons + and - go to
end select the 050 parameter
with the button
49
the display shows
.
.
Advertisement
