Toshiba LF620 Instruction Manual page 48

Switch operation Display example
R1
10.0000
m/s
ESC
R1
10.0000
m/s
R1
10.0000
m/s
R1
10.0000
m/s
R1
05.0000
m/s
R1
05.0000
m/s
SET OK?
ESC
R1
10.0000
N O
m/s
Push
to check or change.
The screen changes and the currently set
item appears for you to check.
Pushing
screen.
When you push
on the setting value and the screen is ready
to change the setting value.
Ready to change the setting value
Pushing
the place where the cursor is positioned.
(Holding down the switch longer causes the
operation to continue.)
* Pushing
below the digit of unit will change the unit to the
next unit. In addition, if a natural number is used, a
decimal point as well as the numeric value appears.
Ready to change the setting value
Pushing
next digit.
Ready to change the setting value
Change the setting value using
In this example, 5.000 m/s is set.
Pushing
The cursor disappears and a message
appears to confirm whether it is OK or not.
N O
O K
If you want to cancel the operation, for
example, because the temporarily set data is
incorrect,
temporarily set data to the previous value,
enabling you to change the setting value
again.
Pushing
and exits the setting screen.
− 47 −
6 F 8 A 0 9 2 7
Description
to select the item you want
returns you to the menu
ESC
, the cursor appears
increments the number in
when the cursor is positioned
moves the cursor to the
.
sets the data temporarily.
pushing returns
N O
cancels the setting operation
ESC
and
the