Toshiba LF620 Instruction Manual page 41

・ B ar graph display
Bar graph can be set only for Display 2.
0
R 1
* About Range type, percent display and percent value when bar graph is displayed
When percent display is used, the % value displayed depends on the flow direction. However,
the % value when bar graph is displayed is as shown in the table below.
Range type
Single(forward)
Single(forward)
Bidirectional
(forward/reverse)
Bidirectional
(forward/reverse)
* The set value in 8.2.17 "Output Low Limit Setting" will be output.
• When communications function is used
When HART communication is used, a mark is displayed in the upper field on the display.
When PRFIBUS/Modbus communication is used, if the communication is made between the
PROFIBUS or Modbus option board and the converter main board, a mark is displayed in the upper
field on the display in the same way as in HART communication, while communication between the
PROFIBUS or Modbus option board and the external bus, nothing is displayed.
- 1 0 . 0 0
m / s
100
% value in
Input signal
percent display
Forward direction
50%
Reverse direction
50%
Forward direction
50%
Reverse direction
50%
− 40 −
Graph･･･ The measured value is displayed in bar graph.
The left side of the graph is RL (Range Low limit) and
the right side of the graph is RH (Range High limit).
Scale marks are displayed in increments of 25% inside
the graph.
Range･･･ The range number currently used is displayed.
% value in
bar graph
50%
50%
0%
-50%
50%
50%
0%
-50%
Displayed when communications
function is used
6 F 8 A 0 9 2 7
4−20mA output
12mA
4mA
(Output low lim value*)
12mA
12mA