Table of Contents
Advertisement
Host Interface Connector
The following table lists the pin functions of the 12-pin host interface connector of the EM3396 V2.
PIN#
Signal Name
1
NC
2
VDD
3
GND
4
RX
5
TX
6
USB_D-
7
USB_D+
8
NC
9
Buzz
10
LED
11
Reset
12
nTrig
13
Chapter 4 Interfaces
I/O
-
Not connected.
-
3.3V
power supply.
-
Power-supply ground.
I
TTL level 232 receive data.
O
TTL level 232 transmit data.
I/O
USB_D- differential data signal (optional)
I/O
USB_D+ differential data signal (optional)
-
Not connected.
Beeper output. For the information of beeper driver circuit, see the Beeper
O
section in this chapter.
Good Read LED output. For the information of LED driver circuit, see the
O
Good Read LED section.
I
Reset signal input: Driving this pin low for 100us~500us resets the engine.
Trigger signal input: Driving this pin low for at least 30ms causes the EM3396
I
V2 to start a scan and decode session.
Function
Advertisement
Table of Contents
