Host Interface Connector
The following table lists the pin functions of the 12-pin host interface connector on the EM3095.
PIN#
Signal Name
1
NC
2
VDD
3
GND
4
RX
5
TX
6
USB_D-
7
USB_D+
8
NC
9
Buzz
10
LED
11
NC
12
nTrig
11
Chapter 4 Interfaces
I/O
-
Not connected.
3.3V
-
power supply.
-
Power-supply ground.
I
TTL level 232 receive data.
O
TTL level 232 transmit data.
I/O
USB D- differential data signal
I/O
USB D+ differential data signal
-
Not connected.
Beeper output. For the information of beeper driver circuit, see the
O
Beeper section in this chapter.
Good Read LED output. For the information of LED driver circuit,
O
see the Good Read LED section.
-
Not connected.
Trigger signal input: Driving this pin low for at least 10ms causes
I
the EM3095 to start a scan and decode session.
Function