Assembly Of The Mixing Bowl; Operation Of The Mixer; Complete Operation; Cleaning - Clatronic KM 3648 Instruction Manual

CAUTION:
• Never press the release button (4), if you have placed
the mixing bowl! The mixing bowl tilts.
• Do not operate the mixer without food!
• The glass could crack at high temperatures! Do not fill in
liquids over 60 °C.
• Do not overfill the mixing bowl! Fill in a maximum of
1500 ml (fruit and liquid).
• Foam takes a lot of volume. Reduce the capacity for
liquids that foam vigorously.
• Cut the food into small pieces before operating the
machine.
• Do not fill any hard ingredients such as nuts or coffee
beans into the mixing bowl.
NOTE:
The knives in the mixing vessel are also suited to crush
small amounts of pure ice. Remember, however, that the
operation may blunt the knife.
Recommendation:
If you want to prepare drinks with crushed ice, add the ice
cubes during mixing. The ice is crushed during mixing.
Place the mixing bowl on a stable level surface when filling it.
So you can better place the cover afterwards.

Assembly of the Mixing Bowl

Please refer to our overviews on page 3 and 4.
Check the pre-assembly! The sealing ring (1d), the knife
block (1e) and the screw (1f) must be fitted in the correct
order.
CAUTION:
• Never forget to place the sealing ring on the knife block.
Otherwise, the mixing bowl will leak.
• The screw lock should be tightened properly, making
sure that it goes on straight, not askew.
WARNING:
• Always disconnect the power plug before cleaning.
• Never immerse the appliance in water for cleaning. It could cause
an electric shock or fire.
• The knives in the mixing bowl and the meat grinder are sharp!
There is a risk of injury! Proceed carefully when disassembling,
cleaning and assembling the individual parts.
58
KM3648_all translation@2016.05.30_new

Operation of the Mixer

1. Fill in the crushed ingredients into the mixing bowl.
2. Press the lid firmly on the mixing bowl.
3. Close the refilling opening with the lock. Insert the lock
into the refilling opening and tighten it clockwise.
4. Set the knob to "0".
5. Make sure that the arm is lowered and locked.
6. Remove the safety cover (2) from the drive shaft of the
mixing engine. Press onto the ribbed surface.
7. Place the mixing bowl on the drive shaft of the mixing
engine.
8. Plug the power cord into an approved mains outlet.
9. Select a speed level.
NOTE:
• Short-term operation: Operate the appliance no longer
than 2 minutes when mixing. Allow it to cool down for 1
minute before using it again.
• To refill ingredients, turn off the appliance. Remove the
lock or lid. Continue the operation only with the properly
positioned lid and the refilling opening closed.

Complete operation

1. Set the knob to "0".
2. Disconnect the power plug.
3. Remove the mixing bowl.
4. Lift the lid before pouring out the contents.
5. Clean the parts used as described under "Cleaning".
6. Cover the drive shaft of the mixing engine with the safety
cover.
IMPORTANT NOTE:
Never keep citrus juices or acidic foods in metal bowls.

Cleaning

01.06.16