Table of Contents
Advertisement
What to do if ...
A message appears in the display at the end of the programme
Message
Check dosage
Align the machine
Check load
The messages will appear at the end of the programme and when the washer-
dryer is switched on and need to be confirmed with the OK sensor.
82
Cause and remedy
Excessive foam has built up during washing.
Check the amount of detergent dispensed.
With automatic detergent dispensing check the
dosage amount set.
Observe the instructions on the detergent pack-
aging and the degree of soiling of the laundry.
If necessary, reduce the dosage amount by incre-
ments of 10%.
The smoothing process which the laundry undergoes
at the end of the programme could not be carried out
properly.
Check that the washer-dryer is aligned correctly as
described in "Installation and connection - Level-
ling the machine".
Check whether the maximum delivery height of 1.0
m has been exceeded.
If the fault message appears again, contact the Ser-
vice Department. The washer-dryer can still be used
but with reduced functionality.
There is no laundry in the drum.
The load is too small. The laundry is still damp be-
cause the residual moisture content in the laundry
could not be measured.
In future use a Timed drying programme for small
amounts of laundry.
The amount of laundry exceeded the max. load for
the selected programme.
Observe the maximum loads given in the Pro-
gramme chart.
Advertisement
Table of Contents
