Table of Contents
Advertisement
WASHING
Detergent dispenser drawer
Add detergent in accordance with the
value in the dosage display.
The percentage shown relates to the
amount of detergent recommended by
the manufacturer on the packaging.
40%
= Add slightly less than half
the amount recommended
50%
= Add half the amount recom-
mended
60%
= Add slightly more than half
the amount recommended
75%
= Add three quarters of the
amount recommended
100% = Add the full amount of the
detergent recommended
Please also observe your water hard-
ness range and the maximum load for
the programme you have selected.
Too little detergent results in:
– Laundry not getting properly clean
and with time it may become grey
and hard to the touch.
– Greasy particles clinging to laundry.
– Limescale deposits on the heater ele-
ments.
Too much detergent results in:
– Excessive foam which causes a low
level of agitation and poor wash,
rinse and spin results.
– High water consumption (an addi-
tional rinse cycle will automatically
switch in).
– A burden to the environment.
30
Pull out the detergent dispenser
drawer and add detergent to the
compartments as follows:
Detergent for the pre-wash (divide the
total recommended amount as follows:
⅓ to compartment and ⅔ to com-
partment )
Detergent for the main wash, including
Soak, if selected
/
Fabric conditioner, liquid starch or cap-
sules.
See "WASHING", "Detergent" for fur-
ther information about detergents and
how much to dispense.
Advertisement
Table of Contents
