Table of Contents
Advertisement
en Installation instructions
For ovens – converting the appliance from
natural gas to liquid gas
If the appliance was set to natural gas at the time of
delivery (factory setting) (NG: G20, G25) and is now
being converted to liquid gas for the first time (LPG:
G30, G31):
Tighten all of the bypass nozzles in the appliance
1.
clockwise to the limit stop. You can find additional
information about this in the section entitled
→ "Removing the control panel", Page 38.
Then carry out the steps described in the section
2.
entitled
→ "Setting the bypass nozzles", Page 39.
Then carry out the steps described in the section
3.
entitled
→ "Fitting the control panel", Page 39.
Converting the appliance from liquid gas to
natural gas
If you convert the appliance from liquid gas
(LPG: G30, G31) to natural gas (NG: G20, G25) or if
you already carried out this conversion and then undo
this:
Turn all of the bypass nozzles in the appliance anti-
1.
clockwise by 1/2 rotation for the setting. You can
find additional information about this in the section
entitled
→ "Removing the control panel", Page 38.
Then carry out the steps described in the section
2.
entitled
→ "Setting the bypass nozzles", Page 39.
Then carry out the steps described in the section
3.
entitled
→ "Fitting the control panel", Page 39.
Removing the control panel
1.
If the appliance has an upper cover, remove this.
To do this, open the hob cover, grip the sides
‒
with both hands and pull it upwards. Ensure that
you do not lose the hinges.
38
Remove the pan support grids or the pan support
2.
racks and the burner parts.
If burner connection screws are present on the hob,
3.
remove all of these.
Remove the screws on the right- and left-hand hinge
4.
brackets.
Undo the hob panel at the burner hub and lift it up.
5.
Pull the hob panel forwards.
‒
Remove the knobs on the front panel by pulling
6.
them towards you.
Advertisement
Table of Contents
