Checking The Fuel Pressure - Yamaha WR250F 2017 Owner's Service Manual

2. Connect:
• Fuel hose
ECA
NOTICE
• Connect the fuel hose securely, and check
that the orientation of the installed fuel
hose holder is correct.
• Take care not to kink or pinch the fuel
hose.
TIP
• Insert the fuel hose into the fuel pipe securely
until you hear a "click".
• Slide the fuel hose connector cover "1" at the
hose end in the direction of the arrow.
• Install the fuel hose connector holder "a".
• Check that the fuel hose and the fuel pump
lead are routed through the guide on the cov-
er.
1
3. Connect:
• Fuel pump coupler
4. Install:
• Air scoop (left/right)
• Seat
• Side cover (left/right)
Refer to "GENERAL CHASSIS" on page 5-
1.

CHECKING THE FUEL PRESSURE

EAS2GBB348
1. Check:
• Fuel pressure
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the side cover (left/right), the seat
and the air scoop (left/right).
Refer to "GENERAL CHASSIS" on page 5-
1.
b. Remove the fuel tank bolt and lift the fuel
tank.
c. Disconnect the fuel hose from the fuel
pump.
Refer to "REMOVING THE FUEL TANK" on
page 8-3.
EWA
WARNING
Cover the fuel hose connection with a cloth
when disconnecting it. This is because re-
sidual pressure in the fuel hose could cause
fuel to spurt out when the hose is removed.
ECA
NOTICE
Make sure that the fuel hose is disconnect-
ed by hand. Do not forcibly disconnect the
hose with tools.
d. Connect the pressure gauge "1" and the fuel
pressure adapter "2" to the fuel hose.
Pressure gauge
Pressure gauge
Fuel pressure adapter
Fuel pressure adapter
a
e. Start the engine.
f. Measure the fuel pressure.
Out of specification  Replace the fuel
pump.
Fuel line pressure (at idle)
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
8-5
FUEL TANK
90890-03153
YU-03153
90890-03186
YM-03186
1
300.0–390.0 kPa (3.00–3.90
2
kgf/cm , 43.5–56.6 psi)
2