Yamaha WR250F 2017 Owner's Service Manual page 205

TIP
Use the cap bolt ring wrench "2" to tighten the
damper assembly.
Cap bolt ring wrench
90890-01501
Cap bolt ring wrench
YM-01501
1
3. Adjust:
• Front fork top end "a"
Front fork top end (standard) "a"
5 mm (0.20 in)
a
4. Tighten:
• Pinch bolt (upper bracket) "1"
Upper bracket pinch bolts
21 Nm (2.1 m·kgf, 15 ft·lbf)
• Pinch bolt (lower bracket) "2"
Lower bracket pinch bolts
21 Nm (2.1 m·kgf, 15 ft·lbf)
EWA
WARNING
Tighten the lower bracket to specified
torque. If torqued too much, it may cause
the front fork to malfunction.
5. Install:
• Speed sensor lead "1"
• Plate 1 "2"
2
TIP
Install the speed sensor lead so that its paint "a"
directs as shown and align the bottom "b" of the
plate 1 with the same paint.
6. Install:
• Speed sensor lead "1"
• Plate 2 "2"
TIP
Install the plate 2 in the direction as shown.
2
5-51
1
2
(to the right front fork protector)
Plate 1 bolt
3.8 Nm (0.38 m·kgf, 2.8 ft·lbf)
2
1
(to the right front fork protector)
Plate 2 screw
0.5 Nm (0.05 m·kgf, 0.36 ft·lbf)
1
FRONT FORK
b
a
2
1