Yamaha WR250F 2017 Owner's Service Manual page 191

▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
5. Install:
• Engine stop switch "1"
• Clutch lever "2"
• Clutch lever holder "3"
• Clamp "4"
Engine stop switch screw
0.5 Nm (0.05 m·kgf, 0.36 ft·lbf)
Clutch lever holder bolt
3.8 Nm (0.38 m·kgf, 2.8 ft·lbf)
TIP
• The engine stop switch, the clutch lever, and
the clutch lever holder should be installed ac-
cording to the dimensions shown.
• Pass the engine stop switch lead through the
middle of the clutch lever holder.
6. Install:
• Right grip "1"
• Collar "2"
Apply adhesive to the tube guide "3".
TIP
• Before applying the adhesive, wipe off grease
or oil on the tube guide surface "a" with a lac-
quer thinner.
• Install the grip to the tube guide so that the
grip match mark "b" and tube guide slot "c"
form the angle as shown.
b
1
7. Install:
• Rubber cover "1"
• Throttle grip "2"
TIP
Apply the lithium-soap-based grease on the
throttle grip sliding surface.
8. Install:
• Throttle cables "1"
TIP
Slightly coat the end of throttle cable and inside
of throttle grip with lithium-soap-based grease.
Then, mount the throttle grip onto the handle-
bar.
5-37
HANDLEBAR
64 64
c
3