Table of Contents
Advertisement
10mm 0
WALL MOUNTING PLATE
FLUE OPENING
INSTALLATION & SERVICIN
INSTRUCTIONS FOR WORCESTER BOSCH
WALL MOUNTING PLATE
FLUE OPENING
CAUTION: Ensure there are no pipes, elec
tric cables, damp proof courses or other
hazards before drilling.
SAFETY:
All relevant safety precautions must be under
taken. Protective clothing, footwear, gloves and
safety goggles must be worn as appropriate.
FIXING THE POSITION OF THE WALL
MOUNTING PLATE:
•
The diagram opposite shows the relative
positions of the flue and the fixing of the wall
mounting plate, the mounting plate and pre
plumbing manifold.
► Place the wall mounting plate against the
wall in the desired position.
► Mark 3 fixing points through the holes (A, B,
C) in the wall mounting plate.
► Drill the 3 holes for wall mounting plate, wall
hanging bracket and pre-plumbing manifold.
► Secure wall mounting plate with hanging
bracket with 3 screws (supplied with the
boiler). Do not fully fasten the lower 2
screws.
► Use the horizontal slots in the wall mounting
plate to level the hanging bracket, mark the
4th hole and drill.
► Fix and secure the hanging bracket with
both screws.
FLUE OUTLET
► Follow the diagram opposite to mark the
centre of the flue for rear outlet (1, & 2) or
for side outlet (2 & 3).
** Note: increase this height by 52 mm for
every 1000 mm of horizontal length that the
flue outlet is away from the boiler.
► For the 60/100 mm 0 flue make a 125 mm
diameter hole through the wall using a core
drill or similar.
For flues using an optional weather collar,
fitted from inside the building make a
150 mm 0 hole.
► Clear away any debris.
FIXING THE PRE-PLUMBING MANIFOLD:
► Mount the pre-plumbing manifold on the 2
lower screws and secure the screws.
^WORCESTER
REENSTAR 25CDÍ/30CDÍ/35CDÍ/40 CDi
6 720 611 927b (04/05)
Bosch
roup
Advertisement
Table of Contents
