Wall Mounting Plate I Flue Opening - Bosch Worcester GREENSTAR CDi Series Instruction Manual

10mm0
-
min. 5 mm
WALL MOUNTING PLATE
FLUE OPENING
-...:
'
-
: ; ~ - = - - -
'
hdeAf
0
!
I
'
I
'
I
'
I
'
OJ
~
0
6 720 611927-04.10
0
WALL MOUNTING PLATE
FLUE OPENING
CAUTION: Ensure there are no pipes, elec-
tric cables, damp proof courses or other
hazards before drilling.
SAFETY:
All relevant safety precautions must be under-
taken. Protective clothing, footwear, gloves and
safety goggles must be worn as appropriate.
FIXING THE POSITION OF THE WALL
MOUNTING PLATE:
The diagram opposite shows the relative
positions of the flue and the fixing of the wall
mounting plate, the mounting plate and pre-
plumbing manifold.
~ Place the wall mounting plate against the
wall in the desired position.
~
Mark 3 fixing points through the holes (A, B,
C) in the wall mounting plate.
~ Drill the 3 holes for wall mounting plate, wall
hanging bracket and pre-plumbing manifold.
~
Secure wall mounting plate with hanging
bracket with 3 screws (supplied with the
boiler). Do not fully fasten the lower 2
screws.
~
Use the horizontal slots in the wall mounting
plate to level the hanging bracket, mark the
4th hole and drill.
~
Fix and secure the hanging bracket with
both screws.
FLUE OUTLET
~ Follow the diagram opposite to mark the
centre of the flue for rear outlet (1, & 2) or
for side outlet (2 & 3).
**
Note: increase this height by 52 mm for
every 1000 mm of horizontal length that the
flue outlet is away from the boiler.
~
For the 60/100 mm
0
flue make a 125 mm
diameter hole through the wall using a core
drill or similar.
For flues using an optional weather collar,
fitted from inside the building make a
150 mm 0 hole.
~
Clear away any debris.
FIXING THE PRE-PLUMBING MANIFOLD:
~ Mount the pre-plumbing manifold on the 2
lower screws and secure the screws.
INSTALLATION & SERVICING INSTRUCTIONS FOR WORCESTER BOSCH GREENSTAR 25CDI/30CDI/37CDI/42
co;
~ O R C E S T E R
6 720 613 700a (2006/11)
Bosch Group