Table of Contents
Advertisement
17.1
ADJUSTING SIGNAL TYPE AND TEMPERATURE RANGE
To adjust the signal type and temperature range:
PGM-key, USEr,
up to Conf, PGM-key,
SiGn, PGM-key, SiGn blinking, with
0 = 0-10 V
1 = 2-10 V
2 = 0-20 mA
3 = 4-20 mA (factory setting)
Takeover of the adjusted value takes place after 2 seconds.
up to 0Pnt (zero point of the temperature range): PGM-key, 0Pnt blinking, with
= factory setting).
up to End (end point of the temperature range): PGM-key, End blinking, with
factory setting).
18
DECOMMISSIONING
Note
No particular measures are necessary for brief decommissioning of the temperature controller.
19
MAINTENANCE
Before carrying out maintenance work, the system and process-specific safety measures must be observed!
Warning
The temperature controller does not require any special maintenance.
The temperature controller should be cleaned with compressed air from time to time depending on the degree
of pollution of the ambient air.
www.mc-techgroup.com
up to OutP, PGM-key,
or
choose signal type:
The place of installation of the temperature controller must be protected from frost also
in the time in which the unit is deactivated.
High voltage.
Before opening the housing, isolate the temperature controller from the sup-
ply!
Temperature controller 70304 | 1.02.00
up to OutA, PGM-key, Out6, PGM-key, Fnct,
or
or
adjust end point (200,0 =
adjust zero point (0,0
19
Advertisement
Table of Contents
