Table of Contents
Advertisement
15
ERROR MESSAGES
Display
Device not calibrated
Measured value
USB communication
EEPROM
16
MEASURED VALUE RECORDING
Display
<<<<
>>>>
- - - -
+ + + +
* * * *
17
DECOMMISSIONING
No special measures are to be taken for decommissioning the equipment.
www.mc-techgroup.com
Cause/remedy or instruction for action
Instruction for action: send the device back to M&C
TechGroup.
The message cannot be acknowledged until it is
within the admissible range again.
Instruction for action: restart device. If the error
message occurs again, send the device back to M&C
TechGroup.
Instruction for action: restart device. If the error
message occurs again, send the device back to M&C
TechGroup.
Cause/remedy or instruction for action
Under range/check sensor configuration, check measuring chain
Over range/check sensor configuration, check measuring chain
Value incorrectly configured (display 1: no selection set). Value
invalid, division by zero, probe short circuit or probe break
Instruction for action: restart device, otherwise return device
Error when recording the terminal temperature or with
compensation signal
Instruction for action: restart device, otherwise return device
Value cannot be displayed, display overrun
Instruction for action: restart device, otherwise return device
Temperature controller 701 | 1.01.00
15
Advertisement
Table of Contents
