Advertisement
SLOTS MUST
POINT UP
2.G) Pull out the lower left rail with the mounting plate installed. Using three
8-32 X 375 PHMS screws (VE7227) secure the door to the mounting plate
as shown.
3.A) Empty included box of kit
contents and place on its side
between the door and cabinet,
near the upper slide. Tighten all
nuts on upper slide.
3.D) Tighten all fasteners.
7
INSTALL NEW DOOR
STEP 3. Mount and Secure Door
3.B) Close the door evenly against the
box between the door and cabinet
as shown. Tighten the middle nut
on right slide only.
3.E) Install DOOR SWITCH (VE159A)
and DOOR STRIKE PLATE
(VE1020757) if not present. Adjust
door switch
VE1021148 - Media Panel Installation Manual
www.veii.com
2.H) Pull out lower right slide and
mount door onto studs with nuts
(VE7207K).
3.C) Close door slowly. Adjust door
position on slides so that the door is
parallel with the cabinet. Verify that
the shim placement allows for the
correct side-to-side alignment.
3.F) Install RUBBER DOOR SEAL
(VE1017065) on left side edge of
door as shown. Ensure it is pushed on
firmly and completely.
Advertisement
