Advertisement
2.3.2 Attaching plusnuts.
NOTE: Check if the holes of the partition align with the holes of the van.
For technical support, contact us at 1-800-565-5321
Put the assembled partition in place, then mark all the holes through the van.
NOTE: • For the B-pilar plastic cover and wood floor use 1" hole saw to
drill a hole in the B-pilar plastic cover or wood floor, then drill 3/8"
hole in the van.
• Enlarge all the holes in the van that align with the holes of the
partiton using 3/8" drill bit or step drill.
TOOLS
q Cordless Drill
q 3/8" Drill Bit or Step Drill
q Drill Stop
Attach plusnuts in the holes.
TOOLS
q Plusnut Tool
q 1" Hole Saw
HARDWARE USED
17×
# 94-130
Plusnut .250
C24-DL Installation Guide | REV. G1 | Page 8
Advertisement
