Switch On, Switch Off; Service And Support; Environmental Protection - Raider RD-EFH05 Original Instruction Manual

Operate this appliance according to the manufacturer's instructions only.

3. Switch on, switch off.

Be careful with the voltage! The voltage of the network must correspond to the data described on the
appliance nameplate. Items marked with 230 V, can be supplied with a voltage of 220 V.
3.1. Place the plug into the socket.
3.2. Switch on (2) of the desired mode. (See the second page). Turn the switch and leave it for 5 seconds in
the positions!
3.3. Turn the thermostat (1) in a clockwise direction to its maximum grade.
3.4. When the room temperature reaches the desired degree, slowly turn the thermostat (1) in counter
clockwise direction until the heater is off. You can hear a slight click. This will set the automatic inclusion of the
heater to a temperature limit.
The heater will maintain the chosen temperature automatically and will switch on and off at certain intervals.
3.5. The heater has built protection against overheating. Thermal circuit breaker.
The appliance has been equipped with an integrated thermal circuit breaker ensuring high safety level. The
breaker will automatically switch the power supply off once a limit temperature is exceeded.
3.6. It is normal some smell to appear when you switch on the fan heater for the first time or if you have not
used it for a long time. This will be short and the smell will gradually disappear.
3.7. To switch off the item, turn the power switch (2) in counter clockwise direction so that the power
switch is at "0" position. Once the heating is off, leave the fan operating for 3 minutes. Then you can unplug the
appliance from the wall socket.
Do not do this by pulling out the power cord!

4. Service and support.

4.1. Always switch off the plug from the socket before cleaning the heater. Wait until it cools down completely!
Use a dry cotton cloth to remove dust. Do not allow water droplets or other liquids to fall inside the heater. When
cleaning the heater, do not use harsh chemicals, abrasive materials or inappropriate chemicals.
The vent of the heater must be always clean and free. Keep the heater in a dry place.
4.2. Functional inspection.
The appliance should be checked at least once a year by competent service personnel approved by the
manufacturer. Any inspections or repairs should be conducted by competent personnel only.

5. Environmental protection.

The unit is supplied in packaging to prevent its being damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to the raw material system. In view of environmental power,
additional accessories and packaging must be subjected to appropriate processing for reuse of
the information contained in these materials.
Do not dispose of household waste power! Under the EU Directive 2012/19/EC on scrapped
electrical and electronic devices and to win recognition as a national power law, which can
be used more, must be collected separately and be subjected to appropriate processing for
recovery of contained therein scrap.
9