Display Box Messages - Vmac AIR INNOVATED H600009 Installation And Owner's Manual

Display Box Messages

The display box presents various context specific messages such as: service
reminders, error messages, or the current state (e.g. "SOFT START xxxC").
System Check
The display will show "VMAC — WWW.VMACAIR.COM" and both the red and
green LED lights will flash.
The display will then show "SYSTEM CHECK / SYSTEM READY" and the system will
go to the "Ready State".
Ready State
The display will scroll through the following messages:
VMAC → PH# 250 740 3200 → HRS: xxxx:xx
The following additional messages may be displayed at this time
500 hour service is due:
"HRS: xxxx:xx 500S"
If the hydraulic fluid temperature is below 5 °F (–15 °C):
"WARM HYD OIL"
Every 100 hrs the system will remind the operator.
"CHECK AIR FILTER"
Initial Startup (see page 43)
During initial startup, the display may show the following messages:
"SOFT START xxxC"
The system has started but the compressor oil is too cold. The compressor is in
"unload" mode and will only build to 40 psi.
"HYD OIL TOO COLD"
The hydraulic fluid is below -13 °F (-25 °C), and the system is cautioning the
operator to preheat the hydraulic fluid (the system will not start until the hydraulic
fluid is above -13 °F (-25 °C)).
"HYD OIL WARMING, HYD xxxF/xxxC"
The hydraulic fluid is between -11 °F (-24 °C) and +5 °F (-15 °C). If installed, the
VMAC Cold Climate Kit will turn on to help warm the hydraulic fluid.
The Hydraulic Driven Air Compressor will not start until the hydraulic fluid has
warmed to 5 °F (-15 °C).
Normal Operation
The system pressure, compressor oil and hydraulic fluid temperatures can be
viewed by pressing the "ON" button while the system is running (use the "ON"
button to scroll through the different messages).
xxxPSI/xxxKPA
COMP xxxF/xxxC
HYD xxxF/xxxC
HRS:xxxx:xx
VMAC - Vehicle Mounted Air Compressors
47
VMAC Technical Support: 888-241-2289
VMAC Knowledge Base: kb.vmacair.com