Table of Contents
Advertisement
OM-2032 / Operation and Maintenance Manual
100D20 / Generator Sets
(5) Change oil filter element
a. Provide a container for catching used oil if the vessel used for draining the crankcase is not
sufficiently wide to serve both operations.
b. Release cartridge (1,Fig. 3) with a wrench and screw off by hand.
c. Clean sealing surface (3) .
d. After slightly oiling the rubber gasket (2) , screw new cartridge in place by hand until gasket is
evenly seated. Give the cartridge a final half turn.
e. After the oil change is complete and the filter replaced, start the engine and check the
shell-to-gasket joint for possible oil leaks.
f.
Engine Accessories
See Figure 1 for identification of engine and accessories lubrication points, intervals, and lubricants.
(1) Starter
The starting motor is lubricated at assembly and should be re-lubricated only when the starter is
removed from the engine or when disassembled.
Remove pipe plugs on outside of motor and apply a few drops of light engine oil to the oil wicks.
March 31/94 Revised
1. Cartridge
2. Gasket
3. Sealing surface
4. Filter Element
Main Cartridge Oil Filter
Figure 4
Chapter 2-1
Page 7
Advertisement
Table of Contents
