Subaru Outback 2017 Owner's Manual page 185

4.
connection is complete.
If an error message is displayed, follow the guidance
on the screen to try again.
NOTE
It may take time if the device connection is carried out during
Bluetooth audio playback.
Depending on the type of Bluetooth device being connected, it
may be necessary to perform additional steps on the device.
AUTO CONNECTION MODE
To turn auto connection mode on, set "Bluetooth Power
device in a location where the connection can be
established.
When the ignition switch is in the "ACC" or "ON"
position, the system searches for a nearby registered
device.
The system will connect with the registered device
that was last connected, if it is nearby.
CONNECTING MANUALLY
When the auto connection has failed or "Bluetooth Power
(Bluetooth Power)" is turned off, it is necessary to connect
Bluetooth manually.
1.
Select and then
(SETTINGS).
2.
Select (Bluetooth).
Bluetooth
3.
Follow the steps in "CONNECTING A Bluetooth
RECONNECTING THE Bluetooth PHONE
If a Bluetooth phone is disconnected due to poor reception
from the Bluetooth network when the ignition switch
is turned to the "ACC" or "ON" position, the system
automatically reconnect the Bluetooth phone.
If a Bluetooth phone is disconnected on purpose,
such as turning it off, this does not happen.
Reconnect the Bluetooth phone manually.
®
Bluetooth SETTINGS
select
SETTINGS
7
183