Calibrating Knife Drive On Harvest Performance Tracker Display M1 Series Windrowers - MacDon R216 Unloading And Assembly Instructions

5.6 Calibrating Knife Drive on Harvest Performance Tracker Display – M1
Series Windrowers
When a header is attached to the windrower, the windrower s Harvest Performance Tracker (HPT) will recognize the
header ID and choose the appropriate settings for that header. Before it can be operated however, the header s knife drive
must be calibrated to ensure that the knife drive pump output is accurate.
DANGER
Ensure that all bystanders have cleared the area.
1. Start the engine.
2. Press soft key 5 (A) to open the Harvest Performance
Tracker (HPT) HPT main menu.
NOTE:
Calibrations MUST be performed with the engine
running. Some calibrations will not be available with the
engine off.
3. Use HPT scroll knob (B) or the ground speed lever (GSL)
scroll wheel (not shown) to highlight SETTINGS icon (C).
4. Press HPT scroll knob (B) or the GSL SELECT button (not
shown) to activate the settings menu options.
5. Scroll to WINDROWER icon (A) and press the HPT
scroll knob.
6. Scroll to CALIBRATION icon (B), and press SELECT to open
the CALIBRATION SELECTION page.
NOTE:
The F3 shortcut button on the operator s console will also
open the WINDROWER SETTINGS menu.
262271
ATTACHING ROTARY DISC HEADER TO WINDROWER
97
B
A
Figure 5.130: Opening the Main Menu
A
Figure 5.131: Windrower Icon and Calibration
Selection Submenu Icon
C
B
Revision A