Table of Contents
Advertisement
30
www.electrolux.com
Problem
In case of an excessive
amount of fluff in the
drum, refer to section
«FLUFF IN THE FAB‐
RICS».
After the check, activate the appliance.
The programme continues from the point
of interruption.
If the problem occurs again, contact the
Authorised Service Centre.
16. INSTALLATION
16.1 Unpacking
WARNING!
Remove all the packaging and the transit bolts before installing the
appliance.
Possible cause/solution
• Thoroughly clean the empty drum, the gasket and the
door with a wet rag.
• Perform a rinse cycle.
• Put a wool or piled fabric rag inside the drum.
• Perform a drying cycle of 10 minutes.
• Remove the old wool cloth.
Now you can wash other garments.
Use the gloves. Remove the external film. If
necessary, use a cutter.
Remove the cardboard top. Remove the
polystyrene packaging materials.
If the display shows other alarm codes.
Deactivate and activate the appliance. If
the problem continues, contact the
Service.
Advertisement
Table of Contents
