Electrolux EWX14742W User Manual page 29

Problem
There is water on the
floor.
You cannot open the
appliance door.
The appliance makes
an unusual noise.
The washing results
are not satisfactory.
The machine does not
dry or does not dry
properly:
The laundry is full of
different coloured fluff:
Possible cause/solution
Adjust manually the items in the tub and start the spin
phase again. This problem may be caused by balance
problems.
Make sure that the couplings of the water hoses are tight
and there is not water leakages.
Make sure that the drain hose have no damages.
Make sure you use the correct detergent and the correct
quantity of it.
Make sure you have replaced the emergency emptying cap
into the filter
Make sure you have properly screwed the filter in after
cleaning.
Make sure that the washing programme is finished.
Set the drain or the spin programme if there is water in the
drum.
Make sure the levelling of the appliance is correct. Refer to
'Installation'.
Make sure that the packaging and/or the transit bolts are
removed. Refer to 'Installation'.
Add more laundry in the drum. The load may be too small.
Increase the detergent quantity or use a different detergent.
Use special products to remove the stubborn stains before
you wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
Make sure that you have set a suitable drying programme
for your laundry.
Make sure that you set the correct the drying time or dry‐
ness degree.
Make sure that the water tap is not turned on.
Make sure the drain filter is not clogged.
Make sure you have not overloaded the appliance.
The fabrics washed in the previous cycle released fluff of a
different colour.
Clean the clothes with a fluff remover
The drying phase helps to eliminate some fluff.
ENGLISH 29