Setting Water Softening System; Special Salt - Bosch SG Series Information For Use

Table of Contents

Advertisement

en Water softening system
Note: Set the water hardness determ-
ined on your appliance.
→ "Setting water softening system",
Page 28
With a water hardness of 0 - 8 °E
you can dispense with special salt
and switch off the water softening
system.
→ "Switching off water softening sys-
tem", Page 29
11.2 Setting water softening
system
Set the water hardness on your appli-
ance.
Determine the water hardness and
1.
the appropriate setting value.
→ "Overview of water hardness set-
tings", Page 27
Press
⁠ .
2.
Press and hold
3.
and
flash.
Release buttons.
4.
repeatedly until the required level
5.
has been selected.
0, 1, 2 or 3 LEDs will light up ac-
cordingly.
→ "Overview of water hardness set-
tings", Page 27
The factory setting is level 1 (LED
A → Page 17).
Press
to save the setting.
6.
a The LEDs go out.
11.3 Special salt
You can use special salt to soften
water.
Adding special salt
If the special salt refill indicator lights
up, add special salt to the dispenser
for special salt just before the pro-
gramme starts. The amount of spe-
1
Depending on the appliance specifications
28
and
until
cial salt required depends on the wa-
ter hardness: the higher the water
hardness, the greater the amount of
special salt required.
ATTENTION!
Detergent may damage the water
softening system.
Only fill the dispenser of the water
softening system with special dish-
washer salt.
Special salt can damage the tub due
to corrosion.
To make sure that any special salt
that escapes is washed out of the
tub, add the special salt to the dis-
penser for special salt immediately
before the programme starts.
Unscrew the lid of the dispenser
1.
for special salt and remove.
On initial start-up: Fill the dispenser
2.
right up with water.
Note: Only use special salt for
3.
dishwashers.
Do not use salt tablets.
Do not use table salt.
Add the special salt to the dis-
penser.
1
Funnel
Fill the dispenser right up with spe-
cial salt. The water in the dis-
penser is displaced and forced
out.
a

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sm seriesSb series4 seriesSmv40c40gbSmv50c10gb

Table of Contents