Table of Contents
Advertisement
Fault
Appliance does not
start.
Programme starts
automatically.
Appliance stops dur-
ing the programme or
cuts out.
Fault
Appliance door can-
not be closed.
Lid on the detergent
dispenser cannot be
closed.
Cause and troubleshooting
The mains fuse has tripped.
Check the relevant fuse.
▶
Mains cable is not inserted.
Check whether the socket works.
1.
Check whether the mains cable is properly inserted
2.
in the socket and on the rear of the appliance.
Appliance door is not closed properly.
Close the appliance door.
▶
You did not wait until programme ended.
→ "Terminate programme", Page 37
▶
Appliance door is not closed properly.
Close the appliance door.
▶
Power and/or water supply has been interrupted.
Check the power supply.
1.
Check the water supply.
2.
Top basket is pressing against inner door and pre-
venting appliance door from being closed securely.
Check whether the rear panel of the appliance is
▶
being pressed in by a socket or hose holder that
has not been removed.
Arrange the tableware so that no parts project bey-
▶
ond the basket and prevent the appliance door
from closing properly.
Cause and troubleshooting
Door lock has been activated.
Close the appliance door with greater force.
▶
Door cannot be closed due to installation method.
Check whether the appliance has been installed
▶
properly.
When closed, the appliance door, its decor or at-
tached parts should not knock against adjacent
cabinets or the worktop.
Detergent dispenser or lid are blocked by sticky deter-
gent residue.
Remove detergent residue.
▶
Troubleshooting en
51
Advertisement
Table of Contents
