Bosch SG Series Information For Use page 43

Fault
Display for water sup-
ply lights up
Display "Check water
supply" flashes
Displays flash
Cause and troubleshooting
Re-insert the filter in the supply hose.
7.
Screw the water connection back on.
8.
Check the water connection for leaks.
9.
Restore the power supply.
10.
Switch the appliance on.
11.
Filters are soiled or blocked.
Clean the filters.
▶
→ "Cleaning filters", Page 40
Wastewater hose is blocked or kinked.
Reposition the wastewater hose without kinks.
1.
Remove residues.
2.
Siphon connection is still sealed.
Check the connection to the siphon and open if ne-
▶
cessary.
Cover of the wastewater pump is loose.
Secure the cover of the Wastewater pump
▶
→ Page 53 so it clicks into position.
A technical fault is present.
Press .
1.
Unplug the appliance or switch off the fuse.
2.
Wait at least 2 minutes.
3.
Insert the mains plug of the appliance in a socket
4.
or switch on the fuse.
Switch the appliance on.
5.
If the problem occurs again:
6.
Press ⁠ .
‒
Turn off the water tap.
‒
Pull out the mains plug.
‒
Contact Customer Service → Page 54 and give
‒
the error code.
Appliance door is not closed properly.
Close the appliance door.
▶
Arrange the tableware so that no parts project
‒
beyond the basket and prevent the appliance
door from closing properly.
Troubleshooting en
43