en Troubleshooting
Fault
Remnants of food on
tableware.
Detergent residue in
the appliance
Water marks on
plastic parts.
46
Cause and troubleshooting
Only remove large remnants of food and do not
▶
prerinse tableware.
Tall narrow receptacles in corner areas are not rinsed
adequately.
Do not position tall narrow receptacles at too great
▶
an angle or in corner areas.
Top baskets on right and left are not set to same
height.
Set the top baskets on the left and right to the
▶
same level.
→ "Top basket", Page 21
Lid of the detergent dispenser is blocked by items of
tableware parts and will not open.
Arrange tableware in the top basket tableware so
1.
the tab collecting tray is not obstructed by table-
ware.
→ "Arrange tableware", Page 34
Items of tableware are blocking the dispenser lid.
Do not place tableware or fragrance dispensers in
2.
the tablet collecting tray.
The lid of the detergent dispenser is blocked by the
tab and will not open.
Position the tab in the detergent dispenser cross-
▶
wise, not vertically.
Tabs are used in the quick or short programme. Dis-
solving time of the tab is not attained.
Select a more intensive Programme or use Powder
▶
detergent → Page 31.
Washing effect and dissolving performance are re-
duced after a prolonged storage time or detergent is
very lumpy.
Change your detergent → Page 31.
▶
Due to laws of physics droplet formation on plastic
surfaces is unavoidable. After drying water marks are
visible.
Select a more intensive programme.
▶
Position tableware at an angle.
▶
→ "Arrange tableware", Page 34
Use rinse aid.
▶
→ "Rinse aid", Page 30
Set the water softening system higher.
▶