Radial And Axial Run-Out Of The Gearbox Shaft End - NEUGART PLE Operating Manual

Operating Manual Gearbox
Commissioning and operation
4.5

Radial and axial run-out of the gearbox shaft end

Information
If the technical specifications include data on the radial and axial run-out of the
output shaft, the measuring methods described below must be used. The measure-
ment may be performed with the gearbox in the horizontal or vertical position, with
the measuring instrument mounted directly on the gearbox or on a common base
plate for the gearbox and measuring instrument. The maximum and minimum
values are read on the measuring instrument by slowly rotating the shaft.
Radial run-out
of the gearbox shaft end
for stem shafts
E/2
The measuring probe is
placed at the center of the
shaft end.
Radial run-out
of the gearbox shaft end
for flanged shafts
The measuring probe is
placed at the center of the
inner centering diameter of
the flanged shaft.
20
Axial run-out
of the gearbox shaft end
for flanged shafts
The measuring probe is
placed at the outer edge of
the screw-on surface of
the flanged shaft.