Mounting; Attaching The Motor To The Gearbox By Means Of A Clamping System (Motor Attachment) - NEUGART PLE Operating Manual

Operating Manual Gearbox

Mounting

4 Mounting
Caution!
Gefahr
A damaged gearbox may no longer meet its technical specifications.
• The gearbox must not show any mechanical damage, corrosion, or lubricant
leakage.
• The sealing elements must be protected from compressed air and aggressive
cleaning agents. For cleaning, use cold cleaning agents based on a gasoline
hydrocarbon.
• The mounting or removal of output elements or motors by means of striking,
pressing or the like must be avoided in order to protect the bearings. Use pullers
or heat connecting elements to be attached.
• Do not install a damaged gearbox in the application.
• Do not operate a damaged gearbox.
Caution!
Gefahr
The gearbox may no longer fully meet the warranted performance characteristics
or the maximum permissible operating temperature may be exceeded if the mate-
rials used are not sufficiently thermally conductive or if the heat storage capacity is
insufficient due to undersizing or the ventilation is inadequate.
• The application-side materials and sizing for connection geometries must be
specified for sufficient heat flow and heat capacity (e.g. aluminum or steel and
plate size equal to twice flange size).
• Ventilation must be ensured by convection or forced-air ventilation.
4.1 Attaching the motor to the gearbox by means of a clamping system
(motor attachment)
Information
If the gearbox is prepared for mounting a motor by means of a clamping system,
please refer to the mounting instructions supplied with the gearbox for detailed
information on mounting the motor to the gearbox.
10