Connecting The Monitor For Dpbs For The First Time - Dell U3224KBA User Manual

5. Go to Monitor OSD Display, turn On from off in Dell Power Button Sync.

Connecting the monitor for DPBS for the first time

Initial system power state (OFF)
For the first time setting up the DPBS function, please follow below steps:
1. Make sure both the PC and monitor is OFF.
2. Connect the Thunderbolt
3. Press the monitor power button to turn ON the monitor.
4. Both the monitor and PC will turn ON normally. If not, press either the monitor
power button or PC power button to boot up the system.
5. When you connect the Dell OptiPlex 7090/3090 Ultra platform, you may see both
the monitor and PC will turn ON momentarily. Wait for a while (approximately 6
seconds) and both the PC and monitor will turn OFF. When you press either the
monitor power button or PC power button, both the PC and monitor will turn ON.
The PC system power state is in sync with the monitor power button.
NOTE: When the monitor and PC are both at power OFF state at first time,
it is recommended that you turn ON the monitor first, then connect the
Thunderbolt
TM
NOTE: You can power the Dell PC* Ultra platform using its DC adaptor
jack. Alternatively, you can power the Dell PC* Ultra platform using the
54 | Setting up the monitor
UltraSharp 32 Monitor
Brightness/Contrast Aspect Ratio
Input Source Sharpness
Color Response Time
Display Smart HDR
PIP/PBP Dell Power Button Sync
USB
Reset Display
Audio & Webcam
Menu
Personalize
Others
Thunderbolt
upstream
4 cable from the PC to the monitor.
TM
4 cable from the PC to the monitor.
16:9
50
Normal
O
On
O
4
TM
Initial monitor power state (OFF)
Thunderbolt TM 4
Exit