Connecting The Monitor For Dpbs For The First Time - Dell UltraSharp 27 User Manual

Connecting the monitor for DPBS for the first time

Initial system power state(OFF)
For the first time setting up the DPBS function, please follow below steps:
1. Make sure both the PC and monitor is OFF.
2. Connect the Thunderbolt
3. Press the monitor power button to turn ON the monitor.
4. Both the monitor and PC will turn ON momentarily. If not, press either the monitor
power button or PC power button to boot up the system.
5. When you connect the Dell OptiPlex 7090/3090 Ultra platform, you may see both
the monitor and PC will turn ON momentarily. Wait for a while (approximately 6
seconds) and both the PC and monitor will turn OFF. When you press either the
monitor power button or PC power button, both the PC and monitor will turn ON.
The PC system power state is in sync with the monitor power button.
NOTE: When the monitor and PC are both at power OFF state at first time,
it is recommended that you turn ON the monitor first, then connect the
Thunderbolt
TM
NOTE: You can power the Dell PC* Ultra platform using its DC adaptor
jack. Alternatively, you can power the Dell PC* Ultra platform using the
monitor's Thunderbolt
Thunderbolt
TM
* Ensure to check the Dell PC for DPBS supportability.
Thunderbolt
upstream
90W
Thunderbolt
4 cable from the PC to the monitor.
TM
4 cable from the PC to the monitor.
4 cable via Power Delivery (PD); please set
TM
4 Charging to On in Off Mode.
4
TM
Initial monitor power state(OFF)
TM 4
Setting up the monitor | 45