Cornelius IMD Series Installation Manual page 10

Countertop Icemaker IMD Series Installation Manual
Low Water Safety Control - Adjust magnet by bending magnet arm as shown in FIGURE 4 to shut
down unit if the water level drops below the line on the side of the reservoir.
Bin Control - Remove four screws from top of bin cover and lift cover so bin control plate can be manu-
ally lifted until unit shuts down. Release plate and unit will restart (On IMD300-30, IMD600-30, and
IMD600-90 the dispense button must be depressed for 45 seconds before until will start). Replace
screws.
Dispense Switch and Mechanism - By depressing the dispense switch, the dispense mechanism door
on the storage bin will open, and chain, sprockets, and agitator will rotate counterclockwise.
NOTE: If any of these checks or adjustments cannot be achieved, refer to Troubleshooting Sec-
tion of this manual or call our Technical Support Center for assistance at 1-800-238-3600.
Publication Number: 638085277INS - 6 - © 2004-2009, IMI Cornelius Inc.