Table of Contents
Advertisement
11A-11-4
Timing belt side
E
Mitsubishi Motors Corporation
F9Q ENGINE –
"DA CYLINDER HEAD GASKET INSTALLATION
(1) Select a cylinder head gasket of the correct thickness
Highest piston
REN0042
height above
cylinder block mm
< 0.653
0.653 – 0.786
0.786 >
"EA CYLINDER HEAD BOLT INSTALLATION
Caution
D
(1) Fit the washers.
(2) Tighten all the bolts to 30 Nm, then angle-tighten by 50_
(3) Wait three minutes for gasket to settle.
(4) Slacken bolts 1 – 2 until they are completely free.
(5) Tighten bolts 1 – 2 to 25 Nm, then angle-tighten by 213_
REN0183
(6) Carry out the same slackening and torque/angle tightening
Mar. 2001
Cylinder Head
according to the projecting height of the pistons. The
available cylinder head gaskets are shown in the table
below. The thickness of the gasket is indicated by the
number of holes near the end of the gasket (see the
illustration). Measure the projecting height of the pistons.
Based on the highest projection, select a cylinder head
gasket of the correct thickness from the table shown below.
Number of holes
2
1
3
When only the gasket is to be replaced, check the hole
pattern on the old gasket and select a gasket with the
same number of holes.
Caution
D
If a piston or connecting rod, etc. has been
replaced, always measure the projecting height
of the pistons because this may have changed
after replacing these parts.
Do not reuse the cylinder head bolts once removed.
± 4_ in the order shown in the illustration at left.
± 7_.
operations on the remaining bolts 3 – 4, 5 – 6, 7 – 8,
9 – 10.
PWEE0001-A
Gasket thickness
mm
1.35
1.45
1.55
Revised
Advertisement
Table of Contents
